Zapper Instructions - Copper Handles 
|
|
Zapper Instructions - Using Copper Handles1. Connect the Cables to the Zapper Connect the black cables to your Auto-Zap as shown in the picture 2. Wrap the Copper Handles with paper towel    Wrap the handle with paper towel as shown. Tuck ONE end into the handle to secure it  3. Connect the cables to your wrapped Copper Handles     Clip the cables to the copper tubes to ensure that the paper towel is clamped properly; make sure that the alligator jaws clip onto the end with no paper on the inside of the copper tube (as shown) 4. Moisten the paper towels in water as shown   Moisten the wrapped copper handles in fresh water (NOT SALT WATER) by dipping them half-way into a glass of water. If your glass is half full, the water will properly wet the top half by capillary action. 5. Zap! Now your handles are properly wrapped and moistened. Now you can use your zapper.  Hold the Handles and press the START button on your Auto-Zap When you press the START button, check that the TOP GREEN LIGHT is fully ON and lit green. 6. Hold the Handles during the ON cycle; you may release the Handles during the OFF cycle. This picture shows the operation of the Auto-Zap during the ON cycle. Notice that the LOWER GREEN LIGHT is flashing quickly. This picture shows the Auto-Zap during the REST cycle. Notice the LOWER GREEN LIGHT is blinking slowly. |